Toyota Tundra Ignition Switch Stuck

When you step on brake to shift into gear that switch should kick out to release lock so you can shift.

Toyota tundra ignition switch stuck. Just turn the wheel back and forth until the ignition cylinder is freed. It did exactally what I wanted it to when. I have tot urn the key back and forth and move the shifter and even bang on the wheel to get it to come out.

If a new key does not get your ignition to turn then your ignition will need to be worked on. Check on that switch i beleive that switch stuck. It was stuck in the ACC position and wouldnt turn to the lock position in Park.

Information in questions answers and other posts on this site Posts comes from individual. Car just keeps turning over but not starting. Test the relay and if it is closed across the relay without 12V applied to the coil its a bad relay.

Your Tundra stalls because the faulty switch turns off the fuel pump or power to the ignition. If the key releases you need a new solenoid. When this happens the engine will not be able to run until it gets that signal back.

Previously In my old 2001 tundra I located the fuel pump ground wire that was in a loom near the side of the driver seat cut it and installed a switch in line. Vehicles Affected The Saturn ignitions tend to stop turning because of worn keys and worn ignitions. I have a 2011 Tundra and recently my key has been getting stuck in the ignition when Im turning the vehicle off.

Our last video upset some people as it was a guide for removing the ignition lock from the. If this is the case youll need to get a new one. Change the switch if it is your problem.