2010 Toyota Tundra Oil Light Reset

The procedure is applicable to the second-generation Toyota Tundra pickup truck 2007 to 2010.

2010 toyota tundra oil light reset. It may ruin the engine. Go to the Settings menu by using the navigation button. Or follow the link above and see how.

All information how to reset low engine. Hold knob for at least 5 seconds until 000000 is displayed and light turns off. With your left hand push the Trip Reset button.

Its in the new owners manual supplement for the 2010 Tundra that just came out. Turn the key to the on position accessories but not powering up the carPress the display button until you reach trip AContinue to hold while trip A is sele. Oil Change Light Reset Toyota Tundra 2010 2011 2012 2013 2014 2015 Procedure Turn the ignition to the RUN position.

Toyota Sequoia and Tundra maintenance required light reset. After youve changed the oil you can reset the light yourself it will not return until the next scheduled oil change. Boom your done until the next change.

Then hold the trip reset button while turning the key back to the ON position. Make sure trip meter A is displayed and turn the ignition off. I assume the warning light is still on if so get it scanned for fault codes.

Press and hold trip meter reset knob and turn the ignition to the RUN position. With vehicle ignition switched to ON position make sure odometer is showing Tripmeter A then turn the ignition switch to OFF position. To reset the 2006 Toyota Tundra maintenance light please follow these instructions.