2007 Toyota Tundra Dash Removal

Remove glove box.

2007 toyota tundra dash removal. Pull the dash toward you starting at the bottom corner to the right of the steering wheel until the corner comes free exposing the panel below the climate controls. Remove the three screws that secure the blend door actuator to the passenger side of the HVAC air distribution housing. Using a 2 Phillips screwdriver remove 1 screw from just behind the inboard drivers knee panel.

Asked by bfulda in Manahawkin NJ on January 08 2010. Remove the blend door actuator from the air distribution housing and disconnect the HVAC wire harness connector from the actuator. Unfortunately for me the diagram doesnt match my truck.

Pull off that panel being careful not to damage any of the wiring behind it. I am way too lazy right now to look it up but I have had my dash apart a couple of times from info on here. It will need to be pulled into the passenger compartment and then brought downward.

Center Console Organizer Tray Fit for Toyota Tundra 2007-2021 Sequoia 2008-2021. There are probably more but thats all I can fathom at the moment. Remove four 10mm bolts.

Unclip the right side of the instrument panel trim and pull back the trimthen unclipunplug and remove radio. Replacing the dash speakers is considerably easier than working with the receiver installation and primarily requires prying up each dash grille and removing two screws. Check air filter for dirty how many miles or kms have your car.

At this point Install your mounts ie. Remove the three or four bolts holding the heater case to the dash. 072811 Page 4 of 22 pages e Dislodge the Lower Dash Cover.