2007 Toyota Tundra 4.7 Secondary Air Injection Pump Location

It seems to have a sound motor no miss just no power.

2007 toyota tundra 4.7 secondary air injection pump location. The bypass kit can prevent many of the trouble codes caused by a mechanical failure of the secondary air pump or a secondary air valve saving you as much as a 2000-4000 on a repair bill turn off your CEL and keep the vehicle out of limp mode. An air pump is used on the vehicle to lower tail pipe emissions on start-up. A bad pump is usually the most common issue with the system but electrical issues can cause the pump to fail.

Report 2005 Toyota Tundra 145000 mi Visitor Nead buypass ket for part 17610c. Replacement for Toyota Sequoia 46L 2009-2012 SR-5PremiumLIMITED. The pumps are located in the worst possibly place in the right fender well where all the water dust and debris can get to them.

Note that some applications use more than one relay in the SAI system and that this. Air injection system relay b malfunction and a check engine light. They pump clean air into the emissions sytem at cold start up.

Tundra 46L 2009-2012 SR-5LIMITED. 2007 Toyota Tundra 145000 mi Visitor Truck would start but had no power and was running rough. The SDHQ Air Pump Intake Kit relocates the intake for the failure prone pump from the inner fender well to inside the engine compartment close to the engine intake where it is better protected from the elements up and out of harms way.

2007 Toyota Tundra 47 135k miles. If the relay is bad replace it with the same amperage rating relay as the original. Toyota 47L Air Induction Pump Bypass Kit Exhaust Port Plates Code.

Its the air pump that sits behind the air ln take cover Report. But after 3 months of ownership on a 2013 46L 4x4 Tundra had the secondary AIP fail. Both relays are 50 amp bank one is located in slot 45 and bank 2 is located in slot 46.