2001 Toyota Tundra Ignition Switch Removal

Remove lower instrument panel steering column cover 04459.

2001 toyota tundra ignition switch removal. The key will turn only enough to unlock the steering wheel and put the truck in gear. How to video on Toyota Tundra Key lock cylinder removal. Problems in getting anyone of my keys to turn the ignition.

Slide the cylinder into the lock housing until the stop tab engages the hole in the lock. 2001 Ignition switch assembly. Detach the illumination ring by pulling out the plastic pin on the side.

Make sure both the lock cylinder and column lock are in the ACC position. Secure the switch with its screws. 12 Nov 25 2006.

Slide the cylinder into the lock housing until the stop tab engages the hole in the lock. Get a phillips head screwdriver and remove the 2 screws holding the little off-white connector at the rear of the moduleit has the wires to the ignition running to it. Just be prepared to prove ownership to Toyota in some way.

Make sure both the lock cylinder and column lock are in the ACC position. Hanging lots of junk on a key ring will cause premature wear in an ignition lock. Press the release bottom with this screwdriver as you pull the lock cylinder straight out.

While it would seem like the most likely cause for a key to get stuck in the ignition at first compared to it being a bad key this is not nearly as likely. To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. TOYOTA Genuine 2019 Up Tundra Power Tailgate Lock Kit Standard Wheelbase PK3B6-34JS0.