2001 Toyota Tundra Grease Fittings

King 25 coilovers Nitto Exo Grapplers.

2001 toyota tundra grease fittings. I am unable to find a grease gun tip that will allow me to grease the front U-Joint. The space is too narrow for the standard tip. Most vehicles past the mid 90s dont have zerk fittings anymore to lube.

2018 Toyota Tundra 4WD 2WD Part 54070 sj02132017rev01 Part 54070 2007 - 2018 Toyota Tundra 4WD 2WD 4 Suspension System Part. Make your beloved vehicle perform reliably efficiently and smoothly again with this top-grade AC component from Santech. Grease Fitting in Cross or Front Shaft All Joints.

Right in front of the rear differential. Locate the new upper control arms. Average repair cost is 900 at 165000 miles.

You dont want to force in so much that a gob of grease comes out. I asked at a Toyota dealer and was told that they didnt know how to do it. Pump it in slowly and youll probably hear it being forced out before you see it.

If I take it to a shop to be greased they are likely not to grease it because it is too difficult. Ideally you want to pack the bearings full without forcing any out. For more information please see our Toyota Warranty Page.

Grease Fitting in Cross. A vary small amount slowly seeping out wont hurt just dont overdo it. I seem to remember it was the same for my 98 also.