2000 Toyota Tundra Rear Bumper Removal

Toyota Echo 2004 Hatchback Replace Rear Bumper.

2000 toyota tundra rear bumper removal. -wheel arches take out the clips holding the fender liner to the bumper-attach the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any. -remove the cover of the bumper underneath and Unscrew two screws on each side twisted upside down-around the bottom part Unscrew the screws spun up-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any. Squeeze and push clamps 31 to remove rubber.

Toyota Tacoma 05-15 Tundra 00-06 Rear Bumper Dome Caps set of 2 Genuine Fits. All the same-as-original bumpers from Replace are a perfect option to go if you want to restore and maintain the original look of your vehicle. -assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any-if you have headlight washers disconnected the hoses so the liquid will not escape on earth should prepare a special container.

Find discussions on the Toyota Tundra Diesel TRD Pro SR5 lift kits towing capacity classifieds and more. The hardest part of removing the bumper is getting under the truck and popping the small plastic tabs that hold the black top cover on. I am assuming you have the 5VZ-FE engine which can pull 4900 lbs SR5 or 4750 lbs Limited.

-in the bottom release the latches and remove the grille. Toyota Tundra Rear Bumper Removal. After those bolts are removed you can pull the sides of the cover away from the quarter.

Unplug the connector on the back side of the license plate lights. Remove your license plate. Toyota RAV4 CA20W 2000-2005 -open the hood and unscrew the screws that secure the radiator grill and the front panel.

The tongue capacity of 500 lbs is the weight of the hitchball can take from gravity so you can drop 500 lbs onto the. This will soft the bumper so you push it out easily on the car. There are a bunch of tabs that you have to pinch inorder to remove the big black plastic piece that runs the width of the bumper.