200 Toyota Tundra Rear Axle Bearing Removal

I recently removed and replaced a rear left bearing on my 2008 Toyota Tundra 47 Limited at 73k and noticed something loose where the shaft would eventually be re-inserted.

200 toyota tundra rear axle bearing removal. Luckily an 1-12 schedule 40 steel pipe fit perfectly over the axle. The bearings last a long time but at some point you may need to replace this bearing on you. If all you needed to replace was the oil seal you can now reassemble everything see below bleed the brakes and you are finished.

All Other parts for Harley. Grasping the edges with vice grips and turning the center piece with need lose pliers works well. Also it will fit any symmetrical 4-bolt.

Fits Tundra Axle Shaft - Repair or ReplaceThe Axle Shaft in your Toyota may need to be removed to replace a seal or bearing because of a leak or noise. Use this with your puller to install bearings. Parts like Rear Axle Shaft Hub are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty.

FREE Shipping by Amazon. Waverspeed Rear Wheel Axle Bearing Puller Tool for Toyota Pick-up 4Runner 1984-2002 for Toyota Hilux 2004-2012 for Toyota T100 1992-1997. Rear Wheel Bearing and Axle Shaft Oil Seal Removal.

There is a TSB on it as well T-SB-0297-10. Next clean up the axle flange surface and replace the O-ring or use gasket-maker instead. After the axle is removed disconnect the service tool.

To get started after pulling the axle I removed the retainer clip on the axle. Although it seems Brian is mainly focussed on Tundra and 200-Series Land Cruisers the rear axle assemblies are very similar to the 100-Series. Remove the axle shaft from the backing plate.